Recent content by Carguy1959

Just wondering if there are any updates on Mr Vetters progress

Also the bracket for the gauges had to be bent forward a bit to clear the fairing, this wasn't a big deal.

There is also about 10 other things I had to do, measure both sides of the bracket and make sure it is even in the back and front on both sides.

Just curious, are you a member on the CB1100 forum? Basically I measured everything (about 20 times). Then I removed head light, turn signals, oil cooler from motor. Than I worked on the bracket until it fit, flairing out the mounts, I had to trim the one that is long on top. I tried to make...

Here is some updated pictures. Better fairing with matching lowers.

Here is a updated picture of my bike. I found a fairing in better shape with matching lowers.r

Hello Husky, after further investigation, I think the mount I used on my 14 CB1100 is from a mid late 70's CB750. I found some on eBay that look almost exactly like mine. I have put a better fairing on my bike and found some lowers that had the same pattern. Here is a recent picture.

That is awesome news, sounds like he is well on his way to getting back to normal, or more likely his new normal...

It wasn't that bad, I had to do it in 2 pieces, left and right. I used non backing vinyl, spray glue on both the fairing and the vinyl. Then just worked it on to the fairing, one section at a time.

I don't know if Mr Vetter would be interested in this or not. This is a picture of my 2014 CB1100 with a Windjammer installed. I saw the thread with his photo shopped picture of the red 2013. I bought my bike in August 2015 and found this site. His picture made me want to do this. Thanks for the...

The bracket I used looks like ones I have seen listed on eBay for a early 80's gl1000/gl1100. I didn't have to modify it much. I removed the oil cooler (temporarly) and test fitted it with large tye raps. The frame brackets were very close to fitting. I worked on mounting the bracket first...

Here's a picture of my 2014 CB1100. This is not photo shopped.

I used the factory head light from my 2014 CB1100. A little rigging but it is in there tight and secure.

I bought a bracket off eBay. Didn't say what it was for, but I think it was for a early gl1000/1100. Only had 1 cross bar and the frame mounts were very close. Here is a picture of the mount.

Just finished installing